gimbal does not move

[Gianni Centurione]

hello everyone I have a mavic 2 pro that after a fall the gimbal and a front arm came off, in the gimbal I changed all the motors and the flat cable, once reassembled when I turn on the drone the gimbal does not make any movement but the camera it works perfectly, I borrowed a camera complete with gimbal and card from a friend but I have the same result, the camera works but the gimbal does not move at all .... what else could I control?

 

[Cymruflyer]

Ciao... Probably get more response if you post in English. Try a translator.

 

[Gianni Centurione]

Ciao... Probably get more response if you post in English. Try a translator.

thanks, i edited

 

[jaybee2786]

hello everyone I have a mavic 2 pro that after a fall the gimbal and a front arm came off, in the gimbal I changed all the motors and the flat cable, once reassembled when I turn on the drone the gimbal does not make any movement but the camera it works perfectly, I borrowed a camera complete with gimbal and card from a friend but I have the same result, the camera works but the gimbal does not move at all .... what else could I control?

hello everyone I have a mavic 2 pro that after a fall the gimbal and a front arm came off, in the gimbal I changed all the motors and the flat cable, once reassembled when I turn on the drone the gimbal does not make any movement but the camera it works perfectly, I borrowed a camera complete with gimbal and card from a friend but I have the same result, the camera works but the gimbal does not move at all .... what else could I control?

I believe If you change an arm on a m2p the mother board doesn't recognise it and I am sure there is a youtube video tell you how to register the new arm I believe its a dos program here is the link it may help .

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[Gianni Centurione]

I believe If you change an arm on a m2p the mother board doesn't recognise it and I am sure there is a youtube video tell you how to register the new arm I believe its a dos program here is the link it may help .

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

thank you for the answer but that calibration works if the gimbal is requested recognized, in my case it is not even seen by the app

 

[jaybee2786]

thank you for the answer but that calibration works if the gimbal is requested recognized, in my case it is not even seen by the app

This is not an app gimbal calibration. It's a motherboard check

 

[Rishu]

This is not an app gimbal calibration. It's a motherboard check

Hi all
Yesterday i changed yaw arm , gimbal board (pcb) and gimbal flex on my mavic 2 pro
&
I am facing the same issue
No camera settings icon in general settings
Gimbal not initialising
Camera feed is coming
Done the calibration with python as well but same issue

 

[Cymruflyer]

When I had a gimbal issue, I tried a few places for repair, but most just wanted to replace everything, the camera and the gimbal. In the end I sent it to DJI and in a week they had the problem sorted and including a few hours of labour charges, they asked me to pay $340. I did that and within another week I had a complete replacement drone. Having been through all that bother, I would suggest you just send it to them and they will send you a replacement drone for what ever the charge might be. Cheaper than trying to sell a broken drone and then having to buy another one. Good luck, Ciao.