- Joined
- Feb 2, 2018
- Messages
- 1
- Reactions
- 0
- Age
- 30
So the other day I was flying my drone and I crashed my drone into the side of my work building. It fell 3 stories. I realized the gimbal plate needed to be replaced and so I bought that and replaced it, upon replacing that I tried turing on the Mavic again and seeing if it all works and I get a message that gimbal motor is overloaded.
To answer a few questions:
To answer a few questions:
- I have tried moving the camera back and forth with my fingers.
- I have replaced the gimbal ribbon just yesterday and still have same issue, I also did not see any damage on the original gimbal ribbon when replacing it.
- I have always used the gimbal clamp and only 1 time did I even forget to remove it and for only a few seconds maybe 30 seconds at best. But nothing went wrong for a while and the problem didn't show up till after the crash.