How do I go back to Go 3?

[G-man]

Newbie here, first post. First flight this morning in beginner mode. All went well but all of a sudden my smartphone disconnected from the controller. Using a Nexus 6 with Android 7 plugged into the usb port on the bottom of the controller. Other posts indicate disconnecting can be a problem when using Go 4 and an android phone... happened to me in my first flight, will probably happen again, don't want this to happen when the Mavic is far away. I understand Go 3 is stable so I uninstalled Go 4, installed Go 3. When I started Go 3 it found the Mavic, said I had to use Go 4 and began downloading it. Any workaround for this besides getting a new phone? Thanks!

 

[Robbyg]

I suspect your on .0500 Mavic firmware. First downgrade the Mavic firmware to .0400 and then try the app again. Not 100% sure this will work but security certainly increased under .0500

Rob

 

[Qoncussion]

I suspect your on .0500 Mavic firmware. First downgrade the Mavic firmware to .0400 and then try the app again. Not 100% sure this will work but security certainly increased under .0500

Rob

I have the Nexus 6P, and the GO app crashed or disconnected equally as much on FW 400 as it does on 500.

 

[Robbyg]

Android issue. Not sure what you can do, Some of them work fine but a lot of them have disconnects.

 

[G-man]

Thanks for the responses but I think I need to go back to Go 3. Any ideas as to how to stop migration to 4 or how to downgrade from 4 to 3? Would having both on the phone and choosing 3 each time work?