Just been out for an early morning flight. My plan was to really explore the area, and use all three batteries up. However, towards the end of my 1st battery, I noticed that the Remote Control icon was pulsing on and off on the DJI Go 4 app. No warning messages appeared. All of my signal bars and battery life were good, so I was a bit perplexed and landed immediately. Unprepared to risk a 2nd flight, I returned home.
Upon checking the problem online, it transpires that the pulsing icon meant that there was some radio interference being experienced, and it was nothing to worry about. But worry I did. And it ruined my morning out. If, indeed, there was nothing to worry about, I'd rather not be told of every little detail and would prefer only to have actual concerns flagged up. There's nothing worse than having seeds of doubt planted in one's mind.
I also experienced the collision sensor icon turning red as I descended. This indicated that the sensors were turned off. I'm guessing/hoping that this was just because I'd executed a RTH. But, again, it would be nice to know ALL of the possible reasons why it would show red.
So, to the crux of things..... Is there an absolutely comprehensive list of ALL of the icons, and every single state that they may show? I have pored over the manual and couldn't find the first problem, so know it is incomplete. It sure would be helpful and reassuring to have EVERY possible variation of each icon's status in a nice, handy list that I could take out into the field.
Upon checking the problem online, it transpires that the pulsing icon meant that there was some radio interference being experienced, and it was nothing to worry about. But worry I did. And it ruined my morning out. If, indeed, there was nothing to worry about, I'd rather not be told of every little detail and would prefer only to have actual concerns flagged up. There's nothing worse than having seeds of doubt planted in one's mind.
I also experienced the collision sensor icon turning red as I descended. This indicated that the sensors were turned off. I'm guessing/hoping that this was just because I'd executed a RTH. But, again, it would be nice to know ALL of the possible reasons why it would show red.
So, to the crux of things..... Is there an absolutely comprehensive list of ALL of the icons, and every single state that they may show? I have pored over the manual and couldn't find the first problem, so know it is incomplete. It sure would be helpful and reassuring to have EVERY possible variation of each icon's status in a nice, handy list that I could take out into the field.
Thanks for that, don't know how I missed it.
