MA1 help

[FpvnWV]

Problem?error code 200

Was unit in a crash?yes

What have you tried so far?fact reset, replug cables

What device are you using ( iphone , ipad, Samsung , etc)?lg stylo5

What firmware are you running ( aircraft, remote controller)?latest MA 1

What Go app version are you using?go 4

Any modification? (if so what)none

Did you change anything or install any apps? (if so what)none

Do you have a video or pictures of the problem? My question is this.... If you break an arm in a crash and order a new one, does the new arm HAVE to be soldered to the board or can you connect to the still remaining and undamaged wires? Just talking about the 3 motor and 3 lights wires.

 

[Dakarenduro]

can't help much, but i believe if you buy a new arm you will need to solder. you wouldnt want to risk doing some sort of splice to old wires and havign that fail and cause another crash.

 

[Starz]

Any other process than soldering back to the esc with the new arm would be incorrect.

 

[Detritalgeo]

To be honest it would be more frustrating to splice the wires together than to simply de-solder the old and solder on the new. Just use a little bit of flux and hopefully you have a narrow-tip for the soldering iron.

 

[FpvnWV]

Much appreciated. After getting into it though, can see that some of the thin gimbal wires have also been broken. So time for more parts!