Massive errors. pic inside

[icantdo55]

Error code3
Checked all connections to main board and all look fine. Camera works but is constantly trying to go up and to the right so much the camera gets hot like 170*F hot. Unit activated and loaded firmware fine.
Any ideas?

 

[Florida Drone Supply]

Is this a brand new unit? A little more history of this Mavic Air will help us diagnose your issues.

 

[icantdo55]

It was a brad new unit that had a DOA main board and a new one was swapped into it,

 

[Former Member]

I would return it if possible.

 

[icantdo55]

I only wish it was that easy. Unfortunately that is not and option.

 

[Former Member]

I think the main board was not the only problem.

 

[icantdo55]

Any other ideas where to start looking

 

[DesJardins]

Brand new unit, swapped main board and no option to send it back?

Welp, Start by trying a new main board for a second time and it sounds like you’ll be spending more on top of that

 

[icantdo55]

Brand new unit, swapped main board and no option to send it back?

Welp, Start by trying a new main board for a second time and it sounds like you’ll be spending more on top of that

Yea I'm thinking that too, already sent message to guy I bought board from on eBay. Just was hoping it was something simple.

 

[Detritalgeo]

This is very old... but.. For anyone else.

If you swap the main board you will likely also need to find a DJI shop that will re-flash you Mavic Air to enable the different gimbal to communicate. This goes the other way around as well if you swap out gimbals. Seems to be an effort to prevent DIY repairs..