My mv2 zoom height readout was very inaccurate. Could be -25ft at landing. VPS readings were correct. Went through the calibration routine several times no help. (imu,compass and sensors). DJI said send it in for repair. Sent it in for repair. DJI was very prompt. Got a new drone back in 7 days.
Calibrated imu, compass and sensors. Relinked rc. Flew it at a very level site and had the exact same height readout problem. When VPS readout is at 30ft. altitude readout could be off by 50ft. During takeoff and hover VPS and altitude readings are close but after a few minutes of flying a short distance altitude and VPS become quite different.
Question is this a common problem? Do I just have to live with it? Am I doing something wrong? My first MV2zoom bought in Oct. 2018 was good until I upgraded firmware from .00 to .02. then the problem started.
Calibrated imu, compass and sensors. Relinked rc. Flew it at a very level site and had the exact same height readout problem. When VPS readout is at 30ft. altitude readout could be off by 50ft. During takeoff and hover VPS and altitude readings are close but after a few minutes of flying a short distance altitude and VPS become quite different.
Question is this a common problem? Do I just have to live with it? Am I doing something wrong? My first MV2zoom bought in Oct. 2018 was good until I upgraded firmware from .00 to .02. then the problem started.