MAVIC 3 AUXILIARY LIGHT PROBLEM

[BRS64]

Hello All;



I have a problem with my mavic 3 auxiliary light. Sometimes it nevers works, sometimes it flickers and sometimes it works like totally okey.

When it does not work, i just stop to spin of propellers and run again, %90 lights start to work.

I think that if there is a lack of contact somewhere at light. ıt never comes on but when i just start motors again, it starts to work.

Can it be something about software?

How can i factory reset the drone? This is the only thing that i did not try.

Thanks for your comments.

 

[vindibona1]

If it flickers or intermittently lights that would indicate a loose connection IMO.

 

[BRS64]

If it flickers or intermittently lights that would indicate a loose connection IMO.

This is the only thing that i can guess also but when i restart to motors again it works without any problem.

 

[vindibona1]

go figure

 

[GFields]

Does sound like a loose connection. Contact DJI support. Most likely a warranty case

 

[Dumeinao]

Yeah I would think it was a loose connection, but it could be a bad wiring connector as well. Either way ping DJI.

 

[MS Coast]

This is the only thing that i can guess also but when i restart to motors again it works without any problem.

... until it doesn't, again.

Sounds like a faulty connection.

 

[offtheback]

This is the only thing that i can guess also but when i restart to motors again it works without any problem.

Could be sympathetic vibration affecting the connection or the lamp itself.

 

[BRS64]

today, i took the drone to dji service, they checked and everything seems okey. They just try increase the lenght of metal parts that connects the led.

 

[drjmax]

Most likely and unsympathetic lamp itself.