Mavic 3 classic manual RTH and obstacle avoidance issues.

[lockers86]

Hi,.

My Mavic 3 classic will just sit and hover when I push RTH occasionally jutting back and forth. also when obstacle avoidance is enabled it just thinks it's surrounded my obstacles even when it's 600ft up in clear skies. I've had drone couple of years, had couple of RCs. Now using the Pro.

I've updated all that I can think of. Now I'm at a dead end.

Any suggestions would be greatly appreciated

Thanks

Lockers

 

[tstr14]

Have you made any changes to it, like adding an overlay, changing the props or adding prop guards?

 

[lockers86]

Hi,
No none of the above.
The only thing I have changes are the propellers but obviously that isn't the problem.

 

[Cafguy]

If the Drone is less than 30 meters from its takeoff point it will just hover and will not return to home,

 

[lockers86]

Hi, thanks for the reply but I maybe should have stated I'm not new to the drone world so that being said I've taken every scenario into account and I leave on a farm so tried it where literally nothing can be picked up on the obstacle avoidance.

 

[GadgetGuy]

Hi, thanks for the reply but I maybe should have stated I'm not new to the drone world so that being said I've taken every scenario into account and I leave on a farm so tried it where literally nothing can be picked up on the obstacle avoidance.

Thoroughly clean all the sensors, if you haven't already.