Mavic Air 3D printed leg extensions

[Robothamster]

Does this not interfere with the range as the legs are antennas?

I was talking about the stickers, not the leg extenders - you'd need to ask someone that's used those

 

[Pharaoh]

Does this not interfere with the range as the legs are antennas?

No, they don't block RF signals.

 

[Jackson62]

Thanks! It’s my own design. Cut with a vinyl cutter.

I love this design, I dont know how did you do this but it's look great ! [emoji2]

May we have the files ?

Thanks you in advance

 

[tcope]

Not my design but solid leg extensions:
DJI Mavic Air Extended Feet by josephchh

This is a small stand to launch the Air from. The legs above need to be removed when folded up. This stand does not attach to the Air:
Basic DJI Mavic Air Stand by lightofhonor

 

[Pharaoh]

I love this design, I dont know how did you do this but it's look great ! [emoji2]

May we have the files ?

Thanks you in advance

Sure, here you go. I found the smallest dots don't stick that well, at least with the material I used.

 

[CanadaDrone]

Very cool - and it looks like they lift a lot higher than other options out there. I had the Polar Pro extensions but I didn't like how hard they were to put on, I felt like it wasn't good for my drone. I then learned how easy it was to hand launch/land the Mavic Air and returned them.

 

[Pharaoh]

Very cool - and it looks like they lift a lot higher than other options out there. I had the Polar Pro extensions but I didn't like how hard they were to put on, I felt like it wasn't good for my drone. I then learned how easy it was to hand launch/land the Mavic Air and returned them.

Thanks! These are easy and soft to put on, and they don't scratch the drone. I use them quite often, especially on dusty and grassy surfaces.