Mavic Pro gimbal overload after changing ribbon cable twice.

Brizzel81 · Feb 19, 2019

After replacing the ribbon cable twice, I still get gimbal overload error. Is there anything else I can try? It seems like only one of the motors is super jerky. Not sure what to do.

BD0G · Feb 19, 2019

@Thunderdrones

Former Member · Feb 19, 2019

OP, check each connector on your motor assembly. The one thats jerky might have a bad connector. Just for good measure, you might want to order a new motor assembly.

Brizzel81 · Feb 20, 2019

Thunderdrones said:
OP, check each connector on your motor assembly. The one thats jerky might have a bad connector. Just for good measure, you might want to order a new motor assembly.

View attachment 63487

I was looking at those last night. Wasn’t sure weather to get an aftermarket, or a used OEM. Didn’t want to spend the money and still have the same luck. I bought a Mavic 2 Pro(with Care Refresh)right after I crashed it, but I want to save it, as it seems everything else works fine. Seems like a crime not to.