After replacing the ribbon cable twice, I still get gimbal overload error. Is there anything else I can try? It seems like only one of the motors is super jerky. Not sure what to do.
OP, check each connector on your motor assembly. The one thats jerky might have a bad connector. Just for good measure, you might want to order a new motor assembly.
OP, check each connector on your motor assembly. The one thats jerky might have a bad connector. Just for good measure, you might want to order a new motor assembly.
I was looking at those last night. Wasn’t sure weather to get an aftermarket, or a used OEM. Didn’t want to spend the money and still have the same luck. I bought a Mavic 2 Pro(with Care Refresh)right after I crashed it, but I want to save it, as it seems everything else works fine. Seems like a crime not to.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.