I'm looking for advice. I have a Mavic 1 pro here of a client that calibrates perfectly, flies perfectly but randomly disconnects from the controller.
When it starts up I get a strong interference warning(no matter where I am). There is a gimbal overload error also that occurs but before I replace the ribbon I would like to figure out why the drone disconnects randomly... Sd card has been removed and swapped. Firmware has been downgraded and updated. Dji assistant calibration works fine.
The issue exists using different controllers too(I've tried 2 other controllers). It also happens when flying without a device. Connection while flying is great(full signal 30m away), no warning of interference or calibrate compass... Nothing... Just disconnects and reconnects after RTH had been initiated 5 seconds later.
I've never seen this before... Any help would be greatly appreciated.
When it starts up I get a strong interference warning(no matter where I am). There is a gimbal overload error also that occurs but before I replace the ribbon I would like to figure out why the drone disconnects randomly... Sd card has been removed and swapped. Firmware has been downgraded and updated. Dji assistant calibration works fine.
The issue exists using different controllers too(I've tried 2 other controllers). It also happens when flying without a device. Connection while flying is great(full signal 30m away), no warning of interference or calibrate compass... Nothing... Just disconnects and reconnects after RTH had been initiated 5 seconds later.
I've never seen this before... Any help would be greatly appreciated.
