mavic pro software lockup during sensor calibration

[dave canada]

after going thur the process of calibration it loads to 85% what I,m i missing tried it on a 55 and a 32 in screen I have never had this problem i just got the drone and its been flying for a week then one morning says calibrate and I,ve tried for two days any more suggestions before i take the drone apart

 

[howardK]

if you are trying to calibrate the compass make sure you are far enough away from any steel that may interfere. This includes rebar used in concrete.

 

[dave canada]

if you are trying to calibrate the compass make sure you are far enough away from any steel that may interfere. This includes rebar used in concrete.

no sir obstacle avoidance sensors are acting up maybe today will have solved it +

 

[PottyMouth312]

Try cleaning your sensors. I had this happen to me too in the past. They looked clean to the naked eye, but after blowing the recessed sensors with air and then lightly cleaning each sensor, the sensors finally calibrated. Also, make sure your screen is scaled to the proper size that it needs to be for the calibration tool to work correctly depending on your screen size. My laptop always seems to do the job well. Give it a go. Good luck.

 

[dave canada]

Try cleaning your sensors. I had this happen to me too in the past. They looked clean to the naked eye, but after blowing the recessed sensors with air and then lightly cleaning each sensor, the sensors finally calibrated. Also, make sure your screen is scaled to the proper size that it needs to be for the calibration tool to work correctly depending on your screen size. My laptop always seems to do the job well. Give it a go. Good luck.

thanks alot i got home and hooked up to a different monitor and problem solved !or i should my tlc 32 in roku tv

 

[PottyMouth312]

Good to hear! Glad you’re up and running. Have a good one.

 

[dave canada]

Good to hear! Glad you’re up and running. Have a good one.

I keep an extra pro around just in case and in the search season one is going out of each door of the van works pretty good with litchi ,it gives mavic pro a self preservation when flying missions here in the desert southwest but appreciate it since i,m here have you ever seen the error message (failed to set paramn) when you try to calibrate the camera

 

[PottyMouth312]

No. I have never encountered that issue before.

 

[Kilrah]

Visual sensor calibration is notoriously picky about monitor size/resolution, without any of it being documented.