Mavic would not connect to RC or Assistant after interrupted firmware update

[Mozkito]

I was doing a firmware update and computer and Mavic both froze. after waiting for over an hour to see if it would continue, had to hot start PC and disconnect Mavic. Since that, Mavic starts (lights come on) but would not connect to PC assistant or RC. I suspect the firmware is half way and does not fully start. Help please !!!!

 

[Haloweenhamster]

Mine froze at 86%, left it until the battery went flat, sent it to dji and they wanted €500 so I've had it sent back to me and ordered a core board from @Thunderdrones
If you are in America he also does repair service

 

[Youser]

Mine froze at 86%, left it until the battery went flat, sent it to dji and they wanted €500 so I've had it sent back to me and ordered a core board from @Thunderdrones
If you are in America he also does repair service

Why did they want €500? Out of warranty?

 

[Haloweenhamster]

Had a scuff where it flew off sideways, cosmetic only but added 3 parts of frame and front obstacle detection, due to scuff not covered by warranty

 

[Mozkito]

can anyone help? thanks

 

[Haloweenhamster]

Core board is dead, dji repair or 3rd party repair like thunderdrones as stated above

It should be covered by warranty unless there are ANY other marks or scratches

If mavic in perfect condition then send to dji, if not then there are 3 repairers that I have found on here thunderdrones is the main one