Mini 3 board repair

VitaliyK · 2025-06-20T10:52:17-0400

After drone was drown, I tried to wash it. At one point I made main board response. As I hade issue with pairing I decided to clean it again. Big mistake

Several resistors were brushed away.
Does anyone have schematic, PCB layout or high quality pictures with visible components? Attached picture with missed resistors.

Max Headroom · 2025-06-20T13:06:00-0400

After drone was drown, I tried to wash it.

You washed your drone, is this a wind up?

Exphantomflyer · 2025-06-20T13:14:36-0400

Pad 7 and 8 looked destroyed, thats a call for a microscope and a very steady hand

VitaliyK · 2025-06-20T13:32:30-0400

Max Headroom said:
You washed your drone, is this a wind up?

I just connected battery, power board and main PCB. I had charging and LED sequences working.

VitaliyK · 2025-06-20T13:35:43-0400

Exphantomflyer said:
Pad 7 and 8 looked destroyed, thats a call for a microscope and a very steady hand

This connector is not used. Actually here is no socket installed. Looks like I just lost several resistors. For LEDs they are 470 ohm and 10 kOhm.
Also I need part number for SMD socket between main and power boards.