Mini 3 Pro bottom feet

[rod.carter]

Just received my M3P from Amazon and I notice there are no rubber feet at the rear, just empty slots.
Is this correct?
There are rubber feet at the front.

 

[rod.carter]

Finally found a bottom image on DPReview and the rear feet don’t have any rubber on them unlike the front ones, panic over.
No real chance to fly it yet except for in the garden, but impressed with the quietness compared to my Mavic Pro.

 

[Macinfo]

There are of course slews of YT Videos showing the drone from virtually every angle, and some have discussed how the drone sits based on how the footings are setup on the Mini 3... There was one from Pilot Institute I think that showed 3d printed footings that could mount on the front motor mounts.. if I recall correctly.. to alter how the drone sits when on the ground.

 

[stuc123]

Mines the same just had a look online there all the same..

 

[rod.carter]

I realised after posting that the rear feet are actually part of the battery and not the drone itself.
Some form of extension feet would be handy, but would most likely take the weight above 250gms, which in the UK/EU is important.