Ok, Today I hooked up the crashed mavic pro to the go4 app and it said some updates were in order, I had not got this far before,
not holding my breath I clicked update and
all went well.
I then decided to check the error messages and I got the familiar gimbal prompts because I haven't fixed that yet. Along with lower vision sensor errors. (see screenshot)
Someone who looked at this bird told me the main board needed to be replaced but I can start up on the desk and it even tells me "No Props"
So I figured I had nothing to lose , so I wanted to see if it would hover and BOOM
, it responded to all commands from r/c through the go4.
So now i think the main board is good and I need the lower vision board.
Is the gyroscope on this board or part of the gimbal board?
When the mavic is hooked into DjI assistant I cannot see any firm ware versions at all, It keeps telling me to retry. Is That relatedt o the lower board also.
sorry for the long winded post.
not holding my breath I clicked update and
all went well.I then decided to check the error messages and I got the familiar gimbal prompts because I haven't fixed that yet. Along with lower vision sensor errors. (see screenshot)
Someone who looked at this bird told me the main board needed to be replaced but I can start up on the desk and it even tells me "No Props"
So I figured I had nothing to lose , so I wanted to see if it would hover and BOOM
, it responded to all commands from r/c through the go4.So now i think the main board is good and I need the lower vision board.
Is the gyroscope on this board or part of the gimbal board?
When the mavic is hooked into DjI assistant I cannot see any firm ware versions at all, It keeps telling me to retry. Is That relatedt o the lower board also.
sorry for the long winded post.
