- Joined
- May 2, 2017
- Messages
- 137
- Reactions
- 34
- Age
- 57
My background is electrical and electronic engineering, I built the sinclaire zx81 kit, back in the day, I've been flying for many years.
The mavic pro has me stumped to why the gimbal initialisation procedure was stalling.
The error we all know is the gimbal motor overload warning, turn the mavic upside down, then restart and it works perfectly very odd.
I spent a whole day checking, calibrating everything, downgrade and upgrading firmware, no hard landing or crashes.
Im guessing it's a faulty imu sensor.
I'm here because I have replaced the mavic and want to prevent this happening again.
I'm not going to calibrate or change anything until it tells me to, as the new one works fine.
The mavic pro has me stumped to why the gimbal initialisation procedure was stalling.
The error we all know is the gimbal motor overload warning, turn the mavic upside down, then restart and it works perfectly very odd.
I spent a whole day checking, calibrating everything, downgrade and upgrading firmware, no hard landing or crashes.
Im guessing it's a faulty imu sensor.
I'm here because I have replaced the mavic and want to prevent this happening again.
I'm not going to calibrate or change anything until it tells me to, as the new one works fine.
