Storage of setting in GO4

[ToddCarey]

Where are the setting stored in the application? If I use two different means of controlling the RC, do in need to verify settings in each, or are the setting stored in the M2P?

 

[msinger]

The settings are stored on the drone, batteries, remote controller, and where DJI GO is installed on your mobile device. Most of the settings are stored on the drone. If all you're switching is the remote controller, then mostly all of your settings will remain in place when switching. You'll just need to set the stick mode and button customization (if needed) for each remote controller in the "Remote Controller Settings" section of DJI GO.

 

[ToddCarey]

Thanks for the response. What I am doing is my "primary" viewer is a Samsung Tab A. While I am very happy with the colors and large size screen, on a very bright day the glare is tough even at full brightness and a shade cover in place. My cell phone is a Samsung Galaxy S8+ which has a very good bright screen, even in direct sunlight without a shade. The only problem I have with the S8+ is that I have size 5 fingers and the small screen is sometimes a challenge when going thru some menus. I was thinking I would just use the S8+ on very bright days, but did not know if the settings would carry over (be stored on the drone and RC).