- Joined
- Dec 9, 2016
- Messages
- 325
- Reactions
- 488
- Age
- 55
Getting really annoyed with the Mavic Air SD card slot? This might help?
Meh! I never take mine out and the onboard 8G gives you back up should you need it.. 64G card stays in and I just plug in the air to access both drives.
Easy.
Coskier
Well-Known Member
Saw that idea from someone else recently and used it. Been helpful for sure. Still surprised at the poor design for that.
Meh! I never take mine out and the onboard 8G gives you back up should you need it.. 64G card stays in and I just plug in the air to access both drives.
Easy.
But you do have to unfold the Air and power it on to get data out by cable, right? If I don't power it up I can't see the drive.
Coskier
Well-Known Member
Don’t forget removing the gimbal protector...
Pretty stupid on DJI’s part to require that the MA be powered up to access the storage, particularly the SD card.
I figured out an easy method for opening the back compartment and removing the card as well as putting the micro sd card back in: my kit will always have a US dime in it. That little 10 cent piece allows me to easily open the back slot (works every time) and I use the same dime to push in the card and help slip it out of the slot. That dime is also used to push the card back into the slot.
Pilot25dmc
Well-Known Member
- Joined
- Feb 28, 2018
- Messages
- 115
- Reactions
- 66
- Age
- 45
I bought a small pair of plastic tweezers and keep them in my flight case. Only needed to use them twice since I bought the Air but they work really well.
WayneMHK
Well-Known Member
Meh! That's significantly more trouble than removing the card.Meh! I never take mine out and the onboard 8G gives you back up should you need it.. 64G card stays in and I just plug in the air to access both drives.
Easy.
Yes I too have a pair of tweezers and don,t get what all the fuss is about the card is no trouble with a pair of tweezers
I just bought a 360 camera and the card slot/door is almost exactly the same situation. It's not just a DJI design issue.
Yep, a piece of tape is great. Same goes for the gimbal cover. Put a piece of tape on it so you can't push the power button while the cover is on. You can't install a battery either. Simple.
Dave Phantom
Active Member
- Joined
- Mar 29, 2019
- Messages
- 40
- Reactions
- 14
hockeypop98
Member
I didn't watch the video, but if it suggests adding a tab, I wholeheartedly agree. I put a doubled over piece of surgical tape on all of mine. It's a plus as well for handling, I'm far less likely to drop it.
I prefer keeping all of my cards sized at 32gb, so while out filming for a day, I can film through all of my batteries with out needing to max out one card and switch to the internal storage.
I prefer keeping all of my cards sized at 32gb, so while out filming for a day, I can film through all of my batteries with out needing to max out one card and switch to the internal storage.
PoonDog
Well-Known Member
- Joined
- May 30, 2019
- Messages
- 298
- Reactions
- 313
I tried a 10 in. crescent wrench. Not recomended
Dave Phantom
Active Member
- Joined
- Mar 29, 2019
- Messages
- 40
- Reactions
- 14
