Updard obstacle detected + Sensor calibration error

[KozelSDN]

Hello everyone,
My name is Standa and I begin with flying
I have a problem with DJI Mavic 2 zoom:
At launch the drone does not fly higher than 10 cm, lands and the engine has a speed of 200rpm.
Error message: Updard obstacle detected, see attached photo.
I tried to calibrate the sensors, but the sensors are black during calibration. See attached photo.
Do you have any advise fot this issue?
Thank you in advance,
Stanislav

 

[ff22]

Hello everyone,
My name is Standa and I begin with flying
I have a problem with DJI Mavic 2 zoom:
At launch the drone does not fly higher than 10 cm, lands and the engine has a speed of 200rpm.
Error message: Updard obstacle detected, see attached photo.
I tried to calibrate the sensors, but the sensors are black during calibration. See attached photo.
Do you have any advise fot this issue?
Thank you in advance,
Stanislav

I posted a reply to your other thread in the HELP section.

Good luck

 

[ff22]

I was hoping you would get more replies with some suggestions.