Yep! I had to scrap my skids on both my Mavic Birds after trying to file off the skid material from the sensors but it did not help.
Back to the basic Mavic with no skids and all is A-Ok!
Hope this info helps..
Best regards,
Steve
I also have this same issue with this original version of the ARRIS XL Landing Skid for Mavic Pro. i purchased it back in Feb 2017..
I have two Mavic's now, the first one was rock solid, then i think the combination of the original SKID and the earlier DJI firmware, never a problem. But back...
I updated to .1000 the Mavic, RC and goggles.
Bird went just fine.
Goggles, locked up once and rebooted it self once.
I was flying in the back yard at 1 meter night in FPV with the DJI goggles at .1000 and I lost all visual controll until the goggles rebooted and linked back and FPV was...
That's great news and thanks for posting your status. I too just completed the full upgrade all components including the DJI goggles. Test flight later today and will report status.
Best regards,
Steve
I also had a problem of controll. Took off ok to 360feet then I could not come down, I pushed the left stick down and the Mavic works only descend about a meter every 20 seconds and I started to worry that this would take to much time to land and the battery mite decay to zero by the time it...
Have you Guys try this.
1. Fly to 390 feet.
2. Hover for 10 seconds.
3. Descend down and see if the bird go's in landing mode by its self and you can't descend any faster then a meter ever 20 seconds. I am at .700 and saw this at .900 and not sure wtf it is?
Comments?
Best regards,
Steve
Can you give is a hint on how to add external antenna? I'd like to put a SMA connector on the goggles if all possible for it's worth the gain.
Best regards,
Steve
Hello Nvidia Shield K1 users, i too HAD problems with the new DJI go 4 app crashing and disconnecting as well as lag with Android 7. so I down grated to 6.0.1 and all works well!
To help the processor in the shield, go into airplane mode. limit all background tasks.
For years since 2013 with...
Hello Guys, I received my BT-300FPV yesterday morning and set it up and it did not have the GO 4 app installed. So I got to the BT to properly down load and install it on my glasses.
Initial tests with the GO app already installed on the Mavic started off good until some video breakup. I have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.