slowing down the speed the Mavic turns around

Discussion in 'Mavic Pro Discussions' started by TraP, Nov 6, 2016.

  1. TraP

    TraP Member

    Joined:
    Oct 22, 2016
    Messages:
    11
    Likes Received:
    0
    Any thoughts or suggestions on controlling (slowing down) the speed at which the Mavic turns around (apart from pushing the joystick slowly)? Anything in the settings which we can be set to slow this - just like we can slow down the gimball tilt speed? Thanks!!
     
  2. The Editor

    The Editor Well-Known Member

    Joined:
    Oct 12, 2016
    Messages:
    399
    Likes Received:
    197
    Practice (that's not meant to be sarcastic).
    There is no substitute for putting in stick time to gain fine control
     
  3. msinger

    msinger Well-Known Member
    Approved Vendor

    Joined:
    Oct 12, 2016
    Messages:
    1,215
    Likes Received:
    448
    Location:
    US
    You could slow down the yaw speed by tweaking the EXP/Gain settings in the "Main Controller Settings" --> "Advanced Settings" section of DJI GO. Doing so will prevent you from turning quickly when needed though.
     
    simplyRik likes this.
  4. dinglehead

    dinglehead Well-Known Member

    Joined:
    Oct 13, 2016
    Messages:
    77
    Likes Received:
    44
    Tripod mode
     
  5. msinger

    msinger Well-Known Member
    Approved Vendor

    Joined:
    Oct 12, 2016
    Messages:
    1,215
    Likes Received:
    448
    Location:
    US
    Tripod Mode is crazy slow. It's not something that'll be useful for people on most flights.
     
  6. TraP

    TraP Member

    Joined:
    Oct 22, 2016
    Messages:
    11
    Likes Received:
    0
    Thanks guys. . I guess practice in controlling the sticks is key then.
     
  7. Mako79

    Mako79 Well-Known Member

    Joined:
    Oct 13, 2016
    Messages:
    171
    Likes Received:
    73
    Listen to @msinger in the post above. Drop the YAW EXPO to 0.2. This make the sticks more sensitive near the centre.
     
  8. Bcornell11

    Bcornell11 Member

    Joined:
    Nov 7, 2016
    Messages:
    22
    Likes Received:
    1
    I wish there was a yaw setting similar to the gimbal where you can adjust the rate at which it slows down after panning. Anyone think this might be a potential firmware update?
     
Loading...
Similar Threads - slowing down speed Forum Date
Downtown Columbus, Ohio Photos and Videos Thursday at 10:26 AM
Casey Neistat and Team Hired By CNN - Beam To Shut Down Off Topic Nov 28, 2016
Rotors up or down? General Discussions Nov 27, 2016
Camera Continues to Rotate Up/Down After I Stop Wheel Mavic Pro Help Nov 22, 2016
Silence the lamb - Mavic RC teardown Photos and Videos Nov 19, 2016

Share This Page