Recent content by sbm

I am thinking the same , M3 drifts much more than A2S in the exact same location with same lighting condition. What the use of IR sensor though ? Can anyone explain ? Without drone rotor wash in effect (mine was flying about 25ft above ground) , no stick input , no wind , why a drone drift...

Thanks for the reply What is the Aux led function? There are IR Sensor at the bottom, what is their function.

Hi Friends , A lesson learned today , in a hard way. I was flying my new M3 , it was just hovering 25ft above ground beside a brick wall. the sequence are as below 1>Low light condition 2>It started to hover with bottom AUX LED light on (set to Auto) and Home point updated with 23 GPS. 3>After...

M3 standard Firmware v700 App v1.6.4 Remote + M3 updated by pc assistant. GPS , 30 sat under 50sec on cold boot. After updating the firmware got need compass calibration messege.Calibrated , then got IMU error , reboot the drone and RCN1 , all good. Quick test in night , M3 came home from...

Yes , checked thoroughly. Thanks all for made it clear.

Hi , I am observing an mode switching issue with my M3 , do not know if already discussed. If I cold start M3 with RC-N1 set at C mode or S mode , M3 alwayes get into N mode and act accordingly.On the remote , mode switch is set at C or S but in the app it's showing N.Also it's flying...

Dont know what is happening , but I did refresh both RC-N1 and M3 through Dji assistant 2 and reinstall firmware. After that M3 is showing dual band on transmission page and it is in FCC Mode. Problem is now GPS aquisition, it is taking approx 3min to get 20 sat.

Yes I did check from the usual transmission option page from the App , don't have analyser. But option which I am getting are totally different for A2S and M3. A2S alwayes showing dual band 100% of the time. M3 showing only 2.4 Exact same location all time.

Thanks for the reply. I have both Air2S and Mavic3 , India , CE country as I know. On the exact same location Air2S is in FCC and Mavic 3 is in CE. A2S showing dual band , M3 showing only 2.4 Any hints ? Both are non hacked on firmware and app level. Running latest firmware + fly app 1.5.9

Hello , Does anyone knows Mavic 3 has different hardware for FCC and CE country or it is a globally same model ? Thanks

Open dji fly transmission page , check , if 1km is beside 90db , it's CE , if higher than that then FCC.

Hello All , I am moderately new to drone , just got a brand new AIR2 S fly more. The drone in awesome. But I have observed a strange thing regarding CE and FCC mode. As per the information AIR2S select FCC or CE depends on the GPS location , there is no separate hardware for this model. In my...