Recent content by STEye

So just to clarify, for those who are reading this thread, does your gimbal calibrate perfectly to the horizon, or did you have to adjust the gimbal roll manually?

Looks like a fun family!

Thanks for all the help people. I didn't realize that you needed to enable intelligent flight modes to enable sport mode. I haven't tried it yet, but I'm sure that was the problem.

Beginner mode is off. When I switched to sport mode there was a pop up that said the intelligent modes are turned off. I don't recall needing to click on something? I can take a look again.

I took my Mavic out for a longer distance today and noticed that it was flying slow even in Sport mode. Going out it was going ~15MPH and coming back it maxed out at ~20MPH. I believe that it should be going well over 30MPH if I recall correctly? Anything I should be adjusting to get it to go...

Good stuff man, you have been helpful to me over the years and I thank you. Good to see you venturing into the drone community, another new passion of mine!

Are you the notorious jcase that is well known on XDA?

Adjustment of 10 or .10?

The first tell tale sign of it being off is when I have the MP inside my house. Things like the wall line and the grates on the window show that it is skewed. Then taking it up in the sky, it has a constant angle no matter where I turn.

I had performed the IMU calibration on a perfectly level table (I even used a bubble level). Like I mentioned earlier, I did the gimbal auto calibration with not avail. It is so strange that during the calibration the horizon level is PERFECT, then when it completes, it returns to the slightly...

Can anyone chime in to let me know if their Mavic came perfectly level? I don't know if I need to exchange it for another one?

I have read extensively about flashing firmware on the Mavic AC, however I don't see any threads on flashing the remote controller. The Dank Downloader appears to have matching firmware for the RC for each revision. Is this something you are supposed to do every time you flash the AC? Can it...

Forgot to mention I even calibrated the IMU COLD. I read somewhere that it is more accurate when you put it in the refrigerator before calibrating it. I had left mine outside in ~39 degree weather for about half an hour before calibrating. No such luck, it nets the same results with the tilt.

I have calibrated the IMU and Auto Calibrated the gimbal many times to see if it would level out without needing to use the Gimbal Roll adjustment. I would think it would come from the factory level, or using the Auto Calibrate would level it without needing a manual adjustment.

Anyone have comments? When you got your Mavic new, was your horizon set perfectly from the factory (no gimbal roll correction needed)?