Recent content by urkiata

I plan to replace the dji battery with 6 unit 3s2p 21700 samsung 4800mah, using the dji battery mother board. Is there somebody that could say me what happens when the voltage drop below 3,3V (because the 21700 can reach 2,8V but I don’t know the behavior of the dji mother boardbelow 3,3V)...

I made three times, with three different battery control boards the same experience. First I took apart one battery control board and I soldered the wires to connect two batteries in parallel together but after I’ve done the board doesn’t send voltage to the mavic connector. Then I tried one...

I put my single extra 5200mah lihv Multistar exactly over the standard battery. Seems that the GC is the same as without the extra battery. Do you have any suggestion?

I run 1.03.0700 and 1.04.0000 with 305/306 removed upgraded from 1.03.0700 both have same behavior. Does the gimbal reboot over the air too? How did you solved? Very corious the it happens only when I fly with an extra battery!

Today I tried fly Mavic pro 5200mah livh Multistar with 8331 low noise propeller and I had very bad surprise: the gimbal rebooted several times over the air, and the camera had bad vibration... anybody had same experience issue? Do you ever flown with 8331 low noise propeller with a battery mod...

which is the usual location please?

Hi Raven, I read that you are right to downgrade a mavic pro to 400 firmware. Can you offer this service to me too?