3D printed feet for the air

[charlas]

Going to give these a try later, see how that get on. Save the blades cutting the grass.

 

[Former Member]

I love innovation!

 

[scotte]

Are those the STLs from here? DJI Mavic Air Extended Feet by josephchh - looks like the same ones. I printed a set of those, haven't flown with them yet, but they fit pretty well. I'll probably tweak them to fit a bit tighter. I did need to rotate them to make the tabs/slot more structural. Fun stuff! I printed an Air lens removal tool also, but it didn't come out too well, might try it again in PLA.

 

[charlas]

Are those the STLs from here? DJI Mavic Air Extended Feet by josephchh - looks like the same ones. I printed a set of those, haven't flown with them yet, but they fit pretty well. I'll probably tweak them to fit a bit tighter. I did need to rotate them to make the tabs/slot more structural. Fun stuff! I printed an Air lens removal tool also, but it didn't come out too well, might try it again in PLA.

Yeah same ones, test print was a little loose so tightened them up and ran a little hotter to get the structure.

 

[charlas]

Yeah same ones, test print was a little loose so tightened them up and ran a little hotter to get the structure.

Fit nice, and she flies well, so happy.

May pop a bit of rubber on the bottom to damp any bumps.