- Joined
- May 28, 2018
- Messages
- 447
- Reactions
- 163
- Age
- 50
Yeah same ones, test print was a little loose so tightened them up and ran a little hotter to get the structure.Are those the STLs from here? DJI Mavic Air Extended Feet by josephchh - looks like the same ones. I printed a set of those, haven't flown with them yet, but they fit pretty well. I'll probably tweak them to fit a bit tighter. I did need to rotate them to make the tabs/slot more structural. Fun stuff! I printed an Air lens removal tool also, but it didn't come out too well, might try it again in PLA.