Just got my
MA2 the other day, and last night I hand caught it a couple of times, but I noticed something when I did it. I noticed that it pulled really hard against my hand, so I tested a few things, mainly it trying to keep the same hover location. When I pulled it down and let go it did fly up as it was trying to adjust, but it didn't fly up much. Then I tried pulling it back and let go and when I let go of it, it shot 8-10 ft forward, stabilized and then drifted back to the original location. I tried it one more time, and when I let go it shot forward, flipped over and crashed. Fortunately the only thing that got damage (because I was stupid and on concrete at the time) was a little bit of scuffing on the nose plate and one of the front antenna/legs. Once I made sure everything else was fine, I too it to soft grass area and did a few more tests. I tried pulling the aircraft forward and to each side to see if it did the same things as for the distance it shot forward, and it didn't. It resisted and did shoot back in the opposite direction that I was pulling it, but it only overshot the original position by maybe a foot or so. Tested it again by pulling it towards the rear, and again it shot 8-10 ft forward and then came back. I also tried to not block any of the obstacle sensors other than the ones on the bottom.
Wasn't sure if this might be a bug in the firmware or if it's intended to do that, but wanted to at least share the experience.