I really don't know what is happening with my out fit. 2-3 week old M2P and Crystalsky Ultra. I took off tonight and decided I would have a go at Hyperlapse Waypoint. So I flew to an altitude of 200 ft and out about 500ft. I stopped pointed my camera and then pressed the blue + sign and the app crashed with an error which I cannot remember (I think it was something to do with the launcher) in a white box in the middle of the screen I think saying shut down the app "Wait" or "Ok"... So I clicked Wait and the screen was still greyed over although I could still see the radar window then I clicked OK but nothing changed. I flew back and landed manually. I then rebooted the drone and controller and CS and this time is was ok, I did the Hyperlapse perfectly is then built the video of it and then I pressed the clipboard icon which I think was manifest and it froze again. I pressed the white X in the top right but nothing and again grey over the background. I flew back manually and landed again still with the greyed over screen and pressed the CS back button, then it was back to normal. I didn't do that in flight as I didn't know what might happen. So I am quickly learning no to rely on the CS performance which is not what I was expecting. Have I got a bad piece of kit somewhere I wonder. Maybe the controller is messing about? I will be getting a Smart Controller in a week or so. This may help me eliminate what is going wrong.
I ran the firmware update last night and did refresh and it came up with an error box right at the end but then the error box wnet away and it said it was fine. Is there anything else I should have done after refreshing the firmware?
I ran the firmware update last night and did refresh and it came up with an error box right at the end but then the error box wnet away and it said it was fine. Is there anything else I should have done after refreshing the firmware?
Last edited: