Hello folks.
Bought yesterday a Mavic 2 pro, with "downgraded" zoom gimbal + the fly more kit, from a very precise geek guy,
The drone was in perfect condition, as if new, batteries had 16, 11 and 9 charging cycles respectively.
Brought the drone home, sat up the app and calibration and stuff and went out for some testing, until this evening with sensors disabled cause of darkness, plus poor knowledge of how to stop the tracking "cirle around target" mode, crashed it at a silly low speed and alttude (2 mt) into an iron fence and then on the asphalt.
Resulting in all the propellers broken, minor scratches on the front plate and rear landing foot, scratches on the front lens ring, gimbal body and arm, scratches on the rear left motor, whose bottom cap (the one holding the leds) has come loose, and i think the motor itself has become slightly stiffer to spin.
That was my baptism of air, will update with phictres soon
Care refresh+ activated by the previous owner already expired
After I checked the drone: gimbal and zoom seem to still work, and the drone did fly correctly with both the broken propellers and the new one, i am just worried for the motor, i think it spins slightly stiffer and noisier than the others.
What do you think i should do?
Oh, nice to meet you, of course
Bought yesterday a Mavic 2 pro, with "downgraded" zoom gimbal + the fly more kit, from a very precise geek guy,
The drone was in perfect condition, as if new, batteries had 16, 11 and 9 charging cycles respectively.
Brought the drone home, sat up the app and calibration and stuff and went out for some testing, until this evening with sensors disabled cause of darkness, plus poor knowledge of how to stop the tracking "cirle around target" mode, crashed it at a silly low speed and alttude (2 mt) into an iron fence and then on the asphalt.
Resulting in all the propellers broken, minor scratches on the front plate and rear landing foot, scratches on the front lens ring, gimbal body and arm, scratches on the rear left motor, whose bottom cap (the one holding the leds) has come loose, and i think the motor itself has become slightly stiffer to spin.
That was my baptism of air, will update with phictres soon
Care refresh+ activated by the previous owner already expired
After I checked the drone: gimbal and zoom seem to still work, and the drone did fly correctly with both the broken propellers and the new one, i am just worried for the motor, i think it spins slightly stiffer and noisier than the others.
What do you think i should do?
Oh, nice to meet you, of course
