When I use a CPL on my camera outside I typically frame my shot and then rotate the CPL while I am looking through the finder until I get my desired result. Simple. I just bought a Freewell CPL for my Air 3. I tested it today and it works fine but setting it might be a bit of a challenge. For my test I just looked through the CPL at the scene I was going to shoot with the drone and rotated the CPL to the spot I wanted and put it on the drone and did the shot.
This worked OK but I was wondering is this the typical way folks use the CPL on the drone? It would be a bit cumbersome to to hold the drone up and rotate the CPL while I look at the display on the remote to get the correct setting.
What do you folks do to set your CPL?
This worked OK but I was wondering is this the typical way folks use the CPL on the drone? It would be a bit cumbersome to to hold the drone up and rotate the CPL while I look at the display on the remote to get the correct setting.
What do you folks do to set your CPL?
