Having used the search function nothing came back regarding the above subject line.
All firmware on CS and Mavic current as of today's date.
Good launch with home point recorded and all 17 GPS satellites available on the CS screen.
After 1700 feet from the home point, at 295 feet amsl, I gave the MPP a "forward" stick command but the CS screen was frozen and didn't register any movement from the Mavic.
The Mavic RC screen showed rotor RPM etc. and all the other parameters were good.
As I was LOS, I flew back to the launch area to land.
After landing, swapped Mavic battery, rebooted the CS and RC and flew again with no problems at all.
I believe that the CS was looking for "maps" and was trying to compare this to the current Mavic position.
Would the area in which I launched from been cached on the CS (Maps) at home when connected to WiFi?
The launch site is not too far from where I live.
Any ideas why I got a frozen screen?
All firmware on CS and Mavic current as of today's date.
Good launch with home point recorded and all 17 GPS satellites available on the CS screen.
After 1700 feet from the home point, at 295 feet amsl, I gave the MPP a "forward" stick command but the CS screen was frozen and didn't register any movement from the Mavic.
The Mavic RC screen showed rotor RPM etc. and all the other parameters were good.
As I was LOS, I flew back to the launch area to land.
After landing, swapped Mavic battery, rebooted the CS and RC and flew again with no problems at all.
I believe that the CS was looking for "maps" and was trying to compare this to the current Mavic position.
Would the area in which I launched from been cached on the CS (Maps) at home when connected to WiFi?
The launch site is not too far from where I live.
Any ideas why I got a frozen screen?