Has anyone been able to remove the bell from the motor. I cannot figure out what kind of clip is holding the bell. I would like to do so to replace the bell.
I think it's a press fit or shrink fit, unless there is a clip under that black plastic? 'washer' on the underside of the motor and I haven't been able to get that 'washer' off yet.
If it is a press fit etc. I'd have doubts about the Aluminium? of the mounting base surviving the removal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.