So I flew my drone over land and decided to "catch land it"
I have done this before and it works perfectly fine.
However, when I caught it and tried to land it and swipe to the right... it made the motor go "override"
It said, " motor override," so drone just flew back up maybe 6 feet and hovered. Motor speed on the remote control was around 500-550 rpm (if I remember correctly).
I could not move the drone forward, backward, ascend or descend with the remote control nor could I land it using the DJI go 4 app.
All I could move was the gimbal, take a picture, and record.
During this time, I turned off the "enable vision positioning".
I still could not move the drone.
I tried putting the two joysticks inwards for emergency landing but it did not do anything.
So I waited maybe 18 minutes until it reached 10 percent battery and it landed on it's own.
Firmware is up to date. I calibrated prior to flying.
Any ideas? Besides not catching it anymore.
Thanks a lot
I have done this before and it works perfectly fine.
However, when I caught it and tried to land it and swipe to the right... it made the motor go "override"
It said, " motor override," so drone just flew back up maybe 6 feet and hovered. Motor speed on the remote control was around 500-550 rpm (if I remember correctly).
I could not move the drone forward, backward, ascend or descend with the remote control nor could I land it using the DJI go 4 app.
All I could move was the gimbal, take a picture, and record.
During this time, I turned off the "enable vision positioning".
I still could not move the drone.
I tried putting the two joysticks inwards for emergency landing but it did not do anything.
So I waited maybe 18 minutes until it reached 10 percent battery and it landed on it's own.
Firmware is up to date. I calibrated prior to flying.
Any ideas? Besides not catching it anymore.
Thanks a lot