Firmware update every time I turn the controller and drone on

[wdfly]

Has anyone had an issue where every time you turn the controller on it says there is a firmware update, yet I have the latest. What happens is it says I have an update so I tap the update button. The firmware load go straight to 70%, runs for about 1 minute, the drone reboots and all is good. Turn them off and back on, and it repeats all over again.

 

[TonyPHX]

Has anyone had an issue where every time you turn the controller on it says there is a firmware update, yet I have the latest. What happens is it says I have an update so I tap the update button. The firmware load go straight to 70%, runs for about 1 minute, the drone reboots and all is good. Turn them off and back on, and it repeats all over again.

I recall having this a while back but cannot remember which drone this was happening on. I recall my fix was to do the update via Assistant 2 wired to the computer.

 

[mavic3usa]

I recall having this a while back but cannot remember which drone this was happening on. I recall my fix was to do the update via Assistant 2 wired to the computer.

Agreed and if you already had the latest software, you should do it again with the Assistant 2 and it's called a Refresh. I remember seeing this as well and for me, the Refresh fixed it.