PREFLIGHT CHECKLIST
-Weather, NOTAMS, Flight plan into the wind
-Check tallest obstacles for RTH height
-Disable phone fast charging
-Batteries, control,
crystalsky and phone charged
-Double check that takeoff site doesn't have any metals nearby, avoid sidewalks or anything that may have metal bars inside
-Remove Gimbal Cover and Clamp
-Unfold drone and props
-Inspect drone components - legs, landing gear, sensors, props, gimbal hooks, air inlets, 5 lenses
-Battery secured to the drone
-Check drone is set to RC mode
-Check SD card in slot
-Extend controller antennas
-Check P mode is selected on controller
-Disconnect charging cable from RC (of using external USB)
-Turn on controller
-Turn on drone
-Format SD card if needed
-Confirm batteries are looking good in App (all cells have the same charge) set critical alert to 30%
-Confirm IMU is looking good in DJI Go App
-Confirm Compass is looking good in DJI Go App and is pointing to the right direction - Calibrate Compass if necessary
-Force stop GO4 app, clear background running apps and Run Litchi
-Force stop GO4 app, clear background running apps and Run Litchi
-Confirm Home Point Set correctly
-Set RTH Altitude to appropriate height (remember it climbs to this altitude when engaged)
-Camera focus, exposure and white balance
-AC status light on green
-Foward LEDs ON or OFF
-If flying over water turn sensors OFF
-Start engines and verify sound and vibrations are normal
AFTER TAKEOFF
-Take off, hover at 10m for 10 seconds to acquire precision landing image
-Verify and test all controls
-Confirm VPS reading
-Select desired flight mode
-Start Recording and have fun
AFTER LANDING
-Check battery cells and autodischarge is set to 3 days
-Turn off Mavic
-Turn off controller
-Inspect drone components - legs, landing gear, sensors, props, gimbal hooks, air inlets, 5 lenses
-Attach gimbal clamp and cover
-Enable phone fast charging.