Bought brand new MA a week or two ago, worked amazing. Brilliant. Well done DJI. That was until earlier when I was flying in cold weather and I received an error message “gimbal motor overload”. Not good. So, I land the drone, dry it off in the airing cupboard for a couple hours, and the gimbal still refuses to work. It is stuck and will not move when I move the slider. I have tried the calibration but it gets stuck between 80-89%. After running the drone for a couple minutes, the gimbal feels REALLY hot. It would burn your finger if u kept it on long enough. I have DJI care refresh but I would like to avoid having to get a whole new unit if possible. Thanks for any help guys