New Mavic 2 Zoom with Smart controller January 8 2020;
After the required updating and calibrating; approximately 3 minutes into my 1st flight I received the Gimbal Motor Overloaded warning. The next 12 or so test flights resulted in the same error message at about the same few minutes after take-off. Wind less than 10 MPH, partly cloudy day and approximately 20F.
Test flight indoors or idling on the surface produced no warning messages and the gimbal worked fine.
I just found about and have calibrated the Inertial Measurement Unit and now waiting for outside temperatures to get above 14F. I tested indoors again with normal Gimbal movement.
After the required updating and calibrating; approximately 3 minutes into my 1st flight I received the Gimbal Motor Overloaded warning. The next 12 or so test flights resulted in the same error message at about the same few minutes after take-off. Wind less than 10 MPH, partly cloudy day and approximately 20F.
Test flight indoors or idling on the surface produced no warning messages and the gimbal worked fine.
I just found about and have calibrated the Inertial Measurement Unit and now waiting for outside temperatures to get above 14F. I tested indoors again with normal Gimbal movement.