I have been flying for about three years now. First with a MP and for 18 months now with a M2P. My main interest is videography/photography. Have been lurking on this forum for a couple of years, but this my first posting.
I suffered from a table saw injury 6 weeks ago and got left index and middle finger complete amputation. They were both reimplanted succesfully, but joint damage will restrict mobility and digital nerve recovery remains to be seen in the next few months. Hard work in therapy in the next months will no matter what leave some restrictions.
Gimbal control which uses left index, or in a pinch left middle finger will be near impossible. A serious problem for videography.
After reading a thread last week where it was discussed how to use DJI Assistant to do a remapping of the RC it is possible to change the flight mode control and switch S,P, or T to ATTI, I'm wondering if it is possible to switch the gimbal control dial from left hand side to right, and vice versa. If not by simple programing, would it be possible to physically modify the RC. I such case I would be willing to send it out and have it modify.
Any advises will be appreciated. I would hate to give up one of my favorite hobby.
Thanks in advance
I suffered from a table saw injury 6 weeks ago and got left index and middle finger complete amputation. They were both reimplanted succesfully, but joint damage will restrict mobility and digital nerve recovery remains to be seen in the next few months. Hard work in therapy in the next months will no matter what leave some restrictions.
Gimbal control which uses left index, or in a pinch left middle finger will be near impossible. A serious problem for videography.
After reading a thread last week where it was discussed how to use DJI Assistant to do a remapping of the RC it is possible to change the flight mode control and switch S,P, or T to ATTI, I'm wondering if it is possible to switch the gimbal control dial from left hand side to right, and vice versa. If not by simple programing, would it be possible to physically modify the RC. I such case I would be willing to send it out and have it modify.
Any advises will be appreciated. I would hate to give up one of my favorite hobby.
Thanks in advance