Mavic not remaining stable

[Ktm250]

Good morning,
I have been out this morning with the Mavic to carry on filming a project I am underway with, BUT during the flight she veered of course and was changing altitude by up to 1 mt up and down, I found a very good spot that was flat and level and did a EMU calibration and a compass calibration...
It still continued to move around and change altitude but not as severe.
Any tips would be gratefully received.
Thanks Andy

 

[Pathogen]

When I do a compass recalibration (which is almost never since I did a good one), I look in the DJI GO app settings to the page where it gives real time interference monitor, and then move the Mavic around until I can get the bar reading into the very low green area, and then calibrate

 

[RTJersek]

When I do a compass recalibration (which is almost never since I did a good one), I look in the DJI GO app settings to the page where it gives real time interference monitor, and then move the Mavic around until I can get the bar reading into the very low green area, and then calibrate

Where do you find this realtime interference monitor, I've had my mavic for about a month and I've never seen it

 

[Pathogen]

MC Settings / Advanced Settings / Sensor State / Compass

Sure would be nice if it was easier to access eh?

 

[Capra Vecinului]

How should we read those indicators? I mean, colowise I get it (green = ok; yellow = caution, red = bad); but for ex is an empty bar better than a full green one?

 

[Pathogen]

empty bar, like you mean no interference? lucky!

yes I do believe the bar fills up as interference rises.

 

[RTJersek]

empty bar, like you mean no interference? lucky!

yes I do believe the bar fills up as interference rises.

Oh now I know what your talking about