Hi everyone, I was using litchi for a short mission flight recently which was fine but when it came to land it suddenly dropped from about 2 metres and landed hard.
My question is could it have been caused by the fitment of landing skids which could have been interfering with the downward sensors? although they don't look as though the skids are obscuring the sensors.
Another thing to consider is that when I flew the same mission previously,I took off from a nearby but higher position, would it have used that higher home point as a reference and thought it had landed when in fact where I did land it was about 2 m lower?
Nothing showed up in the logs.
Luckily these skids took the impact and apart from damage to a skid the Mavic was unharmed and flew well again afterwards on the Go App
I attach photos of the skids.
Sorry if it's a stupid question but I'm wary of using these skids again.
Thanks
My question is could it have been caused by the fitment of landing skids which could have been interfering with the downward sensors? although they don't look as though the skids are obscuring the sensors.
Another thing to consider is that when I flew the same mission previously,I took off from a nearby but higher position, would it have used that higher home point as a reference and thought it had landed when in fact where I did land it was about 2 m lower?
Nothing showed up in the logs.
Luckily these skids took the impact and apart from damage to a skid the Mavic was unharmed and flew well again afterwards on the Go App
I attach photos of the skids.
Sorry if it's a stupid question but I'm wary of using these skids again.
Thanks