Mavic Pro not binding

[stefano225]

Just to make a short story I own two Mavic Pro one was purchased brand new and works as it should , and the second one was purchased used but cannot get RC/AC to bind. Today I tried to bind the newer Rc to the used AC and still no luck , I can however control it via wifi/phone connection just fine. Any thoughts what could be wrong with it ?

 

[DanMan32]

Is there evidence the bind button is working? Rick from Drone Valley broke the bind button on his M2. Button on M2 is flimsily attached to the board.

 

[stefano225]

Binding button looks to be ok ,turns red when pressed and doesn't feel stuck .

 

[DanMan32]

Yup, if light turns on, it's good.

 

[stefano225]

bump

 

[ac0j]

You said Mavic Pro. On the pro there is a tiny switch under the SD card flap on the Mavic. That switches from RC to WiFi. Check that switch

 

[stefano225]

It's set to RC when trying to bind , on WIFI I am able to fly the drone .

 

[Canuk]

Did you try using a second devise . My second pro was giving me a hard time using my iPad and go4 trying to bind . I then put my old phone and go4 in the controller and it did the bind in about 4 seconds . I am thinking there is a small glitch with the go4 on my iPad .