"MCTL" on remote controller

[Delano]

hi All

Does anyone perhaps know what the "MCTL" next to the gps signal indicator means on the controller (see attached picture)?

I've started seeing this after updating the controller to the latest firmware on Tues 14th Feb.

The picture was when indoors so in ATTI mode. But flew outside today with 20 satellites perfectly locked on, and still showed MCTL. In both sport and normal mode.

I've read the manual and didnt see this - or missed it.

Thanks

 

[djmarvin]

Manual Control maybe?

 

[Delano]

Manual Control maybe?

I did think that to... but not sure what I was manually controlling! Strange.
All flew fine though so not to bothered, just curious to find out if anyone else had that

 

[tooFLYforayoungGUY]

I had this come up recently two times. Once during an update and the other when flying.


Sent from my iPad using MavicPilots

 

[aetheridge]

Mine now says this after the firmware update and the controller will no longer connect to my iphone.

 

[PiTon]

Hi , When I link a secondary remote to my Mavic Pro, then on my primary remote it says also MCTL , I think it means something like "Main Controller Transmitter Link" .
When I disconnect the second remote it disappaers.
Tony '-)
Correction : " Master Controller Transmitter Link"

 

[ed1nh0]

I think it means something like "Main Controller Transmitter Link" .
When I disconnect the second remote it disappear

So it could be "Master Controller Transmitter Link", since the other one is the slave.

 

[PiTon]

So it could be "Master Controller Transmitter Link", since the other one is the slave.

Yes , ofcourse it should be "Master" ;-)