Hi MM2 pilots
I had my first flight today, and thanks to all your advices,.. it went fine.... but tI will keep practicing and updating my checklist.
I have 2 questions :
1- Minimum number of GPS satellites : When I checked on the UAV app, I had only 10 sats,.. and it was in RED status and because of this it was "No good to flight", but the DJI app saif it was OK to fly. So maybe the UAV app was not tuned correctly, that is why I would to know what is the minimum number of satellites required by the Mini2
2- During this first flight I lost the connection between the Mini2 and the controler a couple of times even I was at 500meters (in open air), and got it back a few seconds after each time. So I tried to test the smart RTH and it worked. Tonight I looked in user manual at the RTH Failsafe. AND a sentence is confusing me "The aircraft will fly backwards for 50 m on its original flight route and ascend to the preset RTH altitude to enter Straight Line RTH. The aircraft enters Straight Line RTH if the remote controller signal is restored during Failsafe RTH", but what is happening IF the signal is NOT restored ? Does-it continue to fly back to Homepoint ?
Thanks in advance to all
I had my first flight today, and thanks to all your advices,.. it went fine.... but tI will keep practicing and updating my checklist.
I have 2 questions :
1- Minimum number of GPS satellites : When I checked on the UAV app, I had only 10 sats,.. and it was in RED status and because of this it was "No good to flight", but the DJI app saif it was OK to fly. So maybe the UAV app was not tuned correctly, that is why I would to know what is the minimum number of satellites required by the Mini2
2- During this first flight I lost the connection between the Mini2 and the controler a couple of times even I was at 500meters (in open air), and got it back a few seconds after each time. So I tried to test the smart RTH and it worked. Tonight I looked in user manual at the RTH Failsafe. AND a sentence is confusing me "The aircraft will fly backwards for 50 m on its original flight route and ascend to the preset RTH altitude to enter Straight Line RTH. The aircraft enters Straight Line RTH if the remote controller signal is restored during Failsafe RTH", but what is happening IF the signal is NOT restored ? Does-it continue to fly back to Homepoint ?
Thanks in advance to all