Sinds a few days my Mavic Pro has a shaking, restarting gimbal.

[Audiorent]

Tomorrow I go to the repairs shop.
I keep you'll posted

 

[MAvic_South_Oz]

I hope someone can help you before you take it on, this has been posted about before, most likely in a few threads on this forum.

I did a search here on the entire forum for > M1P mavic pro gimbal restart in flight < but couldn't find anything eaisly.
Did same search on google, some reading here might help . . .

Google search

Are you using a filter ?
If so, take it off and try it again.

Check the gimbal base tabs are secured where they should be, nd the little rubber band 'shock absorbers' are all ok.

Often a bad ribbon cable can cause this, they wear out sometimes through movement / hard landing, available online, simple repair, loads of youtube tutorials for this.

 

[Little bird]

I hope someone can help you before you take it on, this has been posted about before, most likely in a few threads on this forum.

I did a search here on the entire forum for > M1P mavic pro gimbal restart in flight < but couldn't find anything eaisly.
Did same search on google, some reading here might help . . .

Google search

Are you using a filter ?
If so, take it off and try it again.

Check the gimbal base tabs are secured where they should be, nd the little rubber band 'shock absorbers' are all ok.

Often a bad ribbon cable can cause this, they wear out sometimes through movement / hard landing, available online, simple repair, loads of youtube tutorials for this.

Have go tried a gimbal calibration. All ya can go is give it a

 

[Little bird]

Have you tried a gimbal calibration. All ya can do is give it a tried. Hopefully it will take care of your problem. Good luck.

 

[Audiorent]

I'm not using filter and I did everything obvious to calibrate. There is something broke. I'm going to the repair shop this afternoon and I will see what this is.

 

[Audiorent]

Replacing de flat cable. I can watch it live on YouTube..???

 

[Audiorent]

Almost ready, flatcable was broken Indeed also a connector from the obstacle avoidance board was broke and is replaced.