Recent content by evo400

If you go to drone hacks and download their software , it free for you to adjust the parameters and you can increase the descent rate.. without paying for it!!

Dont worry man. My Air 2 was hacked and running old fw and DJI still replaced it when she dropped out of the sky. Generally speaking, in terms of FW, for the last year nothing much has been added nor improved on Air 2. I still use old .250 firmware and it flies like a dream. Most FW upgrades...

The best option and the free one is to download the modded app from older version, run that app and start the drone then kill the app and just re-start the latest version app. That way the fcc is working as normal and stays activated, plus the airsense works too

Guys , waste of time! Im in the EU and have ADS-B 3W version. Firstly the Airsense ADS-B only works if you have FCC enabled, which in EU must be hacked. Secondly, in order to get warning from ADS-B you need to be in close proximity of an aircraft and such aircraft needs to have ADS-B out...

Hi, I also suspect your board could be damaged. For high precision soldering like that, you always solder the wires first and coat them in descent amount of solder. Then repeat gently on the board connectors and afterwards just lightly join them . Unfortunately those boards dont hold the heat...

Yes the 3W is the ADSB model. For some reason DJI has the Airsense disabled on CE mode. If you spoof location and try in FCC mode the Airsense will be automatically enabled. I can confirm this as I have received the “manned aircraft nearby “ warning

Jus Just to report Airsense works fine outside of North America. I tested it and got the warning " Manned aircraft nearby" .. ( the chances are most user will not experience this warning unless you are on a collision course or in the vicinity of plane. Simple airliners flying couple of...

Yeah tried all cables and using the same Assistant that I used with my previous Air 2.. I will give it another go tomorrow and report. Maybe it needs to do some flying first

Hi. Just received a new Air 2 under warranty as previous was faulty. Im trying to update the software via DJi Assistant, but for some reason this Air 2 will not connect to any of the PCs or macs i have. Its not even recognised as a storage. The previous Air 2 was connecting perfectly. The...

Where could I order that? Id be curious to give it a go and replace the board? cheers

In my experience Air2 is the easiest drone to land in hand. older drones would simply refuse to land based on IR sensors. Air 2 is very forgiving. But reading at your story, if your drone is pulling while you trying to grab, you simply haven't let your Air 2 to land fully. The trick in hand...

the GPS is line of sight so Im not sure how would the drone lose GPS signal if the sky isnt obstructed and unlike in the big citys, there would be little signal refraction? Granted it might lose the signal reception as he enters the chimney but thats all I reckon. I flew my drone in all sorts of...

Hi, As i said before even tho this little drone is awesome, its quite buggy, the FLY app, the firmware, etc. Only updated the firmware the other day, followed by my first flight while getting propeller guards installed warning, ( performance restrictions applied) Second flight I took off...

Its a nice drone. My 3rd DJI. It flies well, the camera is awesome, its light, the battery is good. But, Its very buggy, the FLY app is a total let down.Hoping they will improve it

Im very curious to actually where is this Adsb module installed? Looking online at various Air 2 tear downs, there doesn't seem to be any hardware difference in the both EU and US drones. Im starting to think, the ADSb receiver might be built inside the controller itself.