Right now I'm using two sided 3m sticker for temporary use, after the flight I've remove it from the body, because it doesn't feat in my hard case with strobe on. It's only 16 grams and I'm not afraid to use this double sided 3m sticker because it hold it tough.
Before I had Air 2 and takes hot also, but right now Air 2S gets hotter more than Air 2.
Battery also is hotter than Air 2, but for me this is coming from the Air 2S body.
I've also proceed with hand catching with my old Air 2 like this:
I've decrease the height to the eye line and catch it by hand at the bottom.. at the same with the other hand keep pressing left stick down until cut off...
BUT I'VE REPLACE MY DRONE WITH AIR 2S AND TRY TO DO THE SAME..
but...
I'm using usb-c connection, but I saw that on this cable you have a sign like a small remote control just over the one plug.. so this plug was connected to my phone.. but now I've changed direction and will try with this configuration.. doesn't see the logic this plug to be connected on a scheme...
Thanks, but now I've unplugged cable from remote control to clean it with contact spray and I have seen a small sign on the usb-c connector looks like remote control picture. This is only from one side, but on the other side there's nothing.
Maybe this sign mean to be connected to remote...
Hi guys,
Yesterday during my flight I've recieved a error msg. USB device disconnected (something like that) and my phone was freezing and after that recieved msg. RC disconnected.. so I've turn off rc through button, close all apps on my phone and restart all again during my drone is hovering...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.