4g Dongle signal is weak

[Ozknbas31]

Hello, I have been using the dongle for 2 days. Today the signal is weak and it is 1 tooth. Why did this happen? It does not increase or decrease at all, I tried with another sim card, the problem is the same. I last flew yesterday. My device is Mavic 3, the latest version is installed, dH fcc is available.

 

[Eko]

could it be that, it is due to the gsm operator's network coverage in that area? did you have the flights at the same location? at the same height?

 

[Ozknbas31]

could it be that, it is due to the gsm operator's network coverage in that area? did you have the flights at the same location? at the same height?

There is no problem with GSM. I tried with another GSM. It works one day. It is broken the other day.

 

[k0200679]

Hello, I have been using the dongle for 2 days. Today the signal is weak and it is 1 tooth. Why did this happen? It does not increase or decrease at all, I tried with another sim card, the problem is the same. I last flew yesterday. My device is Mavic 3, the latest version is installed, dH fcc is available.

Do you use hack for FCC?

 

[Ozknbas31]

Yes I guess FCC is blocking it, I will cancel it tomorrow.

 

[GadgetGuy]

Yes I guess FCC is blocking it, I will cancel it tomorrow.

Under FCC, it likely thinks you are in the U.S. where the 4G dongle is deliberately disabled.

 

[k0200679]

Yes I guess FCC is blocking it, I will cancel it tomorrow.

Post in thread 'Mavic 3 Pro (+FCC hack) and 4G dongle'

Mar 17, 2025

I have found a solution to have 4G Enhanced Transmission and FCC mode simultaneously for Mavic 3


After several days of testing I discovered very interesting detail.

It seems that DH emulates that drone is located in US. That’s why FCC is working, and that is why Enhanced Transmission is NOT working because Enhanced Transmission is blocked in states.

But there is 30 minute delay with DJI Enhanced Transmission servers and your remote.

If you switch off your remote and Drone for more than 30 minutes and switch them again, DJI Enhanced Transmission servers check your region again...

• k0200679

• 

 

[GadgetGuy]

Post in thread 'Mavic 3 Pro (+FCC hack) and 4G dongle'

Mar 17, 2025

I have found a solution to have 4G Enhanced Transmission and FCC mode simultaneously for Mavic 3


After several days of testing I discovered very interesting detail.

It seems that DH emulates that drone is located in US. That’s why FCC is working, and that is why Enhanced Transmission is NOT working because Enhanced Transmission is blocked in states.

But there is 30 minute delay with DJI Enhanced Transmission servers and your remote.

If you switch off your remote and Drone for more than 30 minutes and switch them again, DJI Enhanced Transmission servers check your region again...

• k0200679

• 

So what exactly is the workaround to avoid the region check blocking 4G?
Do you first turn on the drone without FCC, letting it region check while setting the HP, and then turn on FCC, which allows you to fly for 30 minutes, before it disables the 4G?

Basically, you can't boot up with FCC already enabled.
You must enable it only after the HP has been set, which gives you 30 minutes of use.

Rinse and repeat.

Is that about right?

 

[Ozknbas31]

Post in thread 'Mavic 3 Pro (+FCC hack) and 4G dongle'

Mar 17, 2025

I have found a solution to have 4G Enhanced Transmission and FCC mode simultaneously for Mavic 3


After several days of testing I discovered very interesting detail.

It seems that DH emulates that drone is located in US. That’s why FCC is working, and that is why Enhanced Transmission is NOT working because Enhanced Transmission is blocked in states.

But there is 30 minute delay with DJI Enhanced Transmission servers and your remote.

If you switch off your remote and Drone for more than 30 minutes and switch them again, DJI Enhanced Transmission servers check your region again...

• k0200679

• 

I have to connect it to the computer constantly because fcc is done on the device.